In Automox for an hour, this computer has bee saying rebooting for the device status. I know this is not the case because I at the physical machine for testing and it is not rebooting. I rebooted the machine multiple times manually and the status is not updating on Automox. Anyone else ran into this issue?
This discussion is archived and closed to replies. Continue it in the Automox Community Slack.
Discuss on SlackWhen it happens to me, if physically rebooting the machine a couple times doesn’t fix, you’ll have to contact support to reset the client from their side. I was told at one point that they were putting in an auto-reset after 24 hours but I haven’t been able to verify that. I see this most often when a machine goes offline in the middle of an Automox process, at least that’s my belief of the cause.
Thanks for the reply. It seems like it is having a mind of its own. I feel the client is disconnected and the commands I am pushing are not reaching it. I have seen that If I reboot the computer or manually check for updates on the computer, Automox updates in the process of where the physical computer is currently.
Posted by Adrian_Cornelius. Replies by RomanBones.